Company News

A replacement conveyor belt length should be confirmed from the verified belt route, take-up type and reference position, available travel, splice method, installer allowance, and roll plan. Buyers should separate the existing recorded length, measured loop, calculated operating length, ordered manufacturing length, and any installation allowance before comparing quotations.

Conveyor belt joint selection should match the belt construction, tensile rating, pulley and take-up conditions, operating duty, conveyed material, site access, shutdown, installer capability, inspection, and responsibility scope. Hot-vulcanized and mechanical joints have different execution and maintenance requirements; neither should be selected from belt width, thickness, or a photo alone.

A bucket elevator belt RFQ should include the bucket and equipment drawings, hole diameter, row count, transverse and longitudinal pitch, row offset, edge and first-hole distances, bucket spacing, fastener and backing arrangement, splice-zone rule, belt construction, finished length, direction, operating data, failure evidence, quantity, packing, destination, and required documents. Buyers should not compare suppliers from width and length alone.

A heat resistant conveyor belt RFQ should include normal and peak material temperatures, peak duration and frequency, measurement point, material size, loading pattern, belt speed, loaded length, contact time, cooling and ventilation conditions, current belt specification, failure symptoms, quantity, packing, destination, and required documents. Buyers should not compare suppliers from one peak temperature or a generic heat-resistant label.

A rubber lining RFQ should divide material supply, fabrication, substrate preparation, fixing materials, installation, site support, inspection, repair, acceptance, packing, and documentation responsibilities. Buyers should compare offers only after the product basis, site conditions, assumptions, exclusions, and responsibility matrix are aligned.

Sidewall conveyor belt replacement should be based on the damage pattern, measured sidewall and cleat profiles, base-belt construction, conveyor geometry, loading, return-side clearance, splice, and requested repair or replacement scope. A complete RFQ should include photos, measurements, operating data, quantity, destination, documents, assumptions, and responsibility boundaries.